오토바이의 오일 필터 교체는 엔진을 깨끗하게 유지하고 원활하게 작동하는 중요한 유지 관리 작업입니다.. 수행 방법에 대한 단계별 가이드는 다음과 같습니다..

첫 번째, 필요한 도구와 재료를 모으십시오. 오일 필터 렌치가 필요합니다, 배수 팬, 새 오일 필터, 그리고 신선한 엔진오일. 오토바이 모델에 맞는 필터가 있는지 확인하세요..

다음, 몇 분 동안 엔진을 작동시켜 예열해 보세요.. 이는 오일 흐름을 더욱 쉽게 돕고 오염 물질이 오일에 부유되도록 합니다..

Once the engine is warm, locate the oil filter. It is usually located near the engine, either on the side or underneath. Refer to your motorcycle’s manual if you’re unsure.

Position the drain pan beneath the oil filter to catch any oil that may spill. Use the oil filter wrench to loosen the filter by turning it counterclockwise. Be careful not to spill any oil on the hot engine or exhaust.

Once the filter is loose, carefully remove it by hand. Be prepared for some oil to spill out. Allow the remaining oil to drain into the drain pan.

새 필터를 설치하기 전에, apply a thin layer of clean engine oil to the rubber gasket on the filter. This helps create a proper seal and prevents leaks.

Hand-tighten the new filter onto the engine by turning it clockwise. Once it is snug, use the oil filter wrench to give it a final quarter turn to ensure it is securely in place.

Now it’s time to add fresh engine oil. Refer to your motorcycle’s manual for the recommended type and quantity of oil. Use a funnel to pour the oil into the designated oil filler hole.

After adding the oil, start the engine and let it run for a few minutes to circulate the new oil. Check for any leaks around the filter and the oil drain plug.

드디어, turn off the engine and check the oil level using the dipstick. Add more oil if necessary to bring it to the correct level.

Changing the oil filter on a motorcycle is a relatively simple task that can greatly improve the performance and longevity of your engine. By following these steps and performing regular oil changes, you can keep your motorcycle running smoothly for years to come.